RMP / mV/V transducers
3.33 mV/V Melt Pressure Transducers
Bridge-output melt pressure sensing for extruder indicators and compatible signal conditioners. Specify rigid stem, flexible capillary or a combined pressure and temperature probe.
Confirm before ordering
- Match bridge excitation and rated sensitivity; 3.33 mV/V is a requested configuration, not a voltage transmitter.
- Confirm the mounting bore, seal seat, tip projection and full thread dimensions.
- Specify R-Cal contacts and percentage from the exact wiring drawing.
Pressure & mounting choices
Specify full scale in PSI or bar: 1,500 PSI ≈ 103.4 bar; 3,000 PSI ≈ 206.8 bar; 5,000 PSI ≈ 344.7 bar; 10,000 PSI ≈ 689.5 bar. Nominal 100 / 200 / 350 / 700 bar ranges are separate specifications.
Review 1/2″–20 UNF, M14 × 1.5, M18 × 1.5 or M22 × 1.5 against the full bore drawing. The thread alone does not define compatibility.
Choose your RMP configuration
Rigid-Stem Melt Pressure Transducer
Compact extruder locations with room for the rear housing
- Output
- 3.33 mV/V requested
- Arrangement
- 3, 6, 9 or 12 in rigid stem
Flexible-Capillary Melt Pressure Transducer
Extrusion lines needing separation between the hot barrel and electronics
- Output
- 3.33 mV/V requested
- Arrangement
- 6 in stem + 18 or 24 in armored capillary
Dual Melt Pressure & Temperature Probe
One mounting location for pressure and melt temperature measurement
- Output
- Pressure bridge + J/K/E thermocouple or Pt100 request
- Arrangement
- Combined probe, rigid or flexible arrangement
MATCH THE PROBE TO THE PROCESS
Send the model. Confirm the details.
Share the existing part number, mounting bore and controls interface for a configuration-specific quotation.